First question... what is the difference between clips and alerts in BI? I currently have 7 cameras, and they're set to record when triggered by motion only (no continuous recording). They're all geared around Camera 1, settings are screenshotted below.
By default BI shows me stored Clips for a given camera, and there will be a series of clips there. However when I switch over to "Alerts" there are far more recordings that I can now see which have been stored. I can't figure out what the distinction is between these Clips and Alerts, do I have something set up incorrectly?
Second question... I use BI mostly for several outdoor cameras, but we have one installed in my baby daughter's room to use as a baby monitor. I have the motion sensor set up to be very sensitive, with a good pre-recording buffer and yet for some reason it's still not picking up on things. Like this morning early she crawled out of her crib and we went back to see how she did it and there was no alert / clip at all. Thoughts?
By default BI shows me stored Clips for a given camera, and there will be a series of clips there. However when I switch over to "Alerts" there are far more recordings that I can now see which have been stored. I can't figure out what the distinction is between these Clips and Alerts, do I have something set up incorrectly?
Second question... I use BI mostly for several outdoor cameras, but we have one installed in my baby daughter's room to use as a baby monitor. I have the motion sensor set up to be very sensitive, with a good pre-recording buffer and yet for some reason it's still not picking up on things. Like this morning early she crawled out of her crib and we went back to see how she did it and there was no alert / clip at all. Thoughts?
