I have a Lechange 4K bullet came that came with my NVR setup. I was able to change the 10.1.1.71 IP to 192.168.10.180 so it would match my network. I did this with config tool. Now when I power the camera up it loads and then works for all of 5 seconds, then its gone from the network again and stays that way until I power cycle. Tinycam says the camera is dropping too many frames. I've tried powering it with an injector as well as a 12v ps and it behaves the same with both setups.
What next? Thanks
Alright, woke up this morning and hooked the camera up directly to my router and it's working fine. Before it was going through an un-managed switch. Why was that a problem?
Update #2. I'm very noob to this. Tried it with the switch again, except this time I rebooted the switch and now it works. What the hell. I spent a lot of time on this last night and went to be angry, lol.
What next? Thanks
Alright, woke up this morning and hooked the camera up directly to my router and it's working fine. Before it was going through an un-managed switch. Why was that a problem?
Update #2. I'm very noob to this. Tried it with the switch again, except this time I rebooted the switch and now it works. What the hell. I spent a lot of time on this last night and went to be angry, lol.
Last edited: