Can't figure out Axis M1124 Camera alarm

Dazcomputers

Dazcomputers

Getting the hang of it
Sep 12, 2017
169
62
milwaukee
This camera has two wires that when connected closes a circuit and when not connected opens the circuit. How can I get the alarm to show up in Blue Iris. When I log into axis communications and touch the wires it shows grounded circuit when I release wires it shows open so I know that it is working. I just can't seem to get it to do this in BI.
 
In the cam, did you set up an 'Action Rule' that responds to 'Input Signal' ? Here's the ==>> manual.
In Blue Iris, did you try setting the 'Trigger' setting 'Camera's digital input' as below?

axis.jpg
 
  • Like
Reactions: Dazcomputers and fenderman
I Did set check the box to use the camera motion but I didn't try to set up the rules. Thanks alot I have some more learning and testing to do. I will try it out when I get back to work. This is a great site. I'm learning so much so fast. So cool
 
You must log in or register to reply here.
Top Bottom