Cancelled alerts with the latest DeepStack?

[Jake1979]

All of the sudden, no one walking or driving down the driveway is being flagged, all I did was upgrade to the latest deepstack last night. I am on 5.5.1.6 for BI.

 

[MikeLud1]

All of the sudden, no one walking or driving down the driveway is being flagged, all I did was upgrade to the latest deepstack last night. I am on 5.5.1.6 for BI.

Sometimes you need to do a full reboot of the PC, see if that works.

 

[Jake1979]

I should have mentioned that. I did that after the upgrade.

 

[MikeLud1]

I am not sure if this might be it, you have "+ real-time images" set to zero try setting it to 5

 

[Jake1979]

Exact same proble, even with the latest BI update. It's cancelled every single motion alert, legitimate ones and even ones I would not want.

Do I need to run some sort of command after an upgrade to enable this? DS used to says Car Person, etc, now it just says "DeepStack: 100".

 

[wittaj]

Uncheck the following:

Begin analysis with motion leading edge

Use main stream if available.

Check the following:

Apply to motion triggers only

See if that gets it working.

 

[Jake1979]

Uncheck the following:

Begin analysis with motion leading edge

Use main stream if available.

Check the following:

Apply to motion triggers only

See if that gets it working.

I can try that but why would I need to do that after the Deepstack upgrade from February version to September?

 

[wittaj]

Or it is going to BI 5.5.1.6 and it is just coincidental that it times with changing the DS version....

Did you uninstall DS and reinstall or just install over?

I did a complete uninstall of DS and reinstalled and have no problems on 5.5.1.6

 

[Jake1979]

Installed over it, I may need to do a clean install. I wish I had notes, but do I need to run this command?
deepstack --VISION-DETECTION True --PORT 80

Under the AI tab it says port 82.

 

[wittaj]

You should not need to run any of those commands. BI should do it automatically when it starts.

Have you confirmed DS is running in BI by hitting the test button?

 

[Jake1979]

Removed DS, deleted folder, reinstalled, rebooted. No go. Used the tested in browser setting and it is activated.

 

[Jake1979]

I know that this is helpful to me when the OP posts what fixed the problem.... so here it is. I was not paying attention, I had installed the GPU version instead of CPU. It's now working as expected.