Camera keeps defaulting to motion detect zone from another camera.

JEO

JEO

n3wb
Feb 8, 2018
11
1
NC Foothills
Last week I used the camera's WEB interface to fine tune the motion detect zones and settings. Yesterday I noticed on Smart PSS that the motion detect zone I set up for my porch cam is showing on my driveway cam. I've reset the motion detect zone for the driveway cam on the WEB, on the Smart PSS NVR and on the Smart PSS camera but when I open the driveway cam later, it again shows the motion detect zone for my porch cam. At least my porch cam isn't showing my driveway zone! Anyone experience anything like this? I rebooted the NVR this morning with no help. driveway.jpgporch.jpg
 
Maybe not an answer directly to your problem, but why don't you use IVS? Works better than motion detection
 
Kameraad said:
Maybe not an answer directly to your problem, but why don't you use IVS? Works better than motion detection
Click to expand...

I probably will. I've only recently set the system up. I wanted to experiment with MD and IVS separately to see how they perform. So far not so impressed with MD.
 
You must log in or register to reply here.
Top Bottom