BI CPU usage increases gradually after the process starts

V

VinAU

Young grasshopper
Jun 20, 2019
61
6
Australia
Hi all,

I am experiencing a strange thing here. I have a well tuned BI deployment which uses about 30-35% cpu when things are quiet, like in the middle of the night. No motion, no recording.

What I have noticed is that over the course of a week or so the cpu usage gradually increases for no apparent reason.

Today in the middle of the night my BI was not recording anything, nothing happening in terms of motion and it was doing close to 60% CPU. This was the BI process only.

So I decided to stop and start it. To my surprise it was down to 30% again. I will check in the morning and at night again to make sure my assessment is correct.

Has anyone seen this behaviour before?

Thanks in advance.


Sent from my iPhone using Tapatalk Pro
 
How many cameras do you have ?
What are there MP?

Please provide a screen shots. full frame (use windows 10 snip & sketch tool)
1) windows task manager process tab sorted by memory (most at the top), Must contain, memory, disk, network, GPU, GPU engine columns
2) windows task manager performance, GPU
3) Blue Iris Setting about tab
4) Blue iris status (lighting bolt graph) clip storage
5) blue Iris status cameras
 
SouthernYankee said:
How many cameras do you have ?
What are there MP?

Please provide a screen shots. full frame (use windows 10 snip & sketch tool)
1) windows task manager process tab sorted by memory (most at the top), Must contain, memory, disk, network, GPU, GPU engine columns
2) windows task manager performance, GPU
3) Blue Iris Setting about tab
4) Blue iris status (lighting bolt graph) clip storage
5) blue Iris status cameras
Click to expand...

I have 7 cameras, three are 5mp, one is 4mp, 2 are one pm and one camera is 2mp.

I will collect the rest of the info. Thanks for the offer to help.

I have a hunch that it could have started after I added sub streams from two cameras to record continuously. These sub streams are 1mp and the other is 0.3mp.


Sent from my iPhone using Tapatalk Pro
 
Are you recording both the main stream and the sub-stream for the same camera? Not sure how to do that.
 
SouthernYankee said:
Are you recording both the main stream and the sub-stream for the same camera? Not sure how to do that.
Click to expand...

The sub streams are recording constantly, there is no motion or alerting of any kind there.

The main streams are only recorded on motion. The sub streams are basically another camera whch I should have added to the list i gave before.
 
Had the same issue back in October. Make sure Intel gpu driver didn’t get updated.. some drivers have a memory leak that leads to these problems
 
Sounds typical of a memory leak. Suggest you check the program / driver versions and update.
 
gfaulk09 said:
Had the same issue back in October. Make sure Intel gpu driver didn’t get updated.. some drivers have a memory leak that leads to these problems
Click to expand...
The newest drivers are all good. Most folks fail to clean install windows and as a result think they cannot install the newest driver because the OS tells them they have the latest.
 
You must log in or register to reply here.
Top Bottom