2/3 Cameras are "black" or bars on desktop but work in phone app

[EngineerFreely]

For awhile only 1 of my 2 cameras were showing properly in BI5. I added a 3rd one and it does the same thing. The phone app works fine. Videos record, no issue. It just does not show correctly in BI5.

See attached for what I mean.

No idea what could be the issue here.

 

[biggen]

Is it paused in the upper right? Make sure its not flashing red.

 

[EngineerFreely]

Is it paused in the upper right? Make sure its not flashing red.

Not paused. Thanks for the reply.

 

[samplenhold]

Post the BI Status Messages Tab and the Cameras tab.

 

[EngineerFreely]

Post the BI Status Messages Tab and the Cameras tab.

Is this what you are looking for? Nothing pops up that I can see here.

I also adjusted the camera slider and the 2 non working ones get all glitchy and are using frames from the 1st camera.

If we are thinking computer issue of some sort...
Dell OptiPlex 9020 Desktop PC 3.20GHz Core i5-4570 8GB w/ 4tb WD Purple, WIN10

 

[samplenhold]

Does this have a graphics card or onboard graphics?

Your iframe rate needs to be equal to the frame rate. Also, why 30FPS? Most folks run at 15FPS.

I suggest writing to the log file.

What happens if you only show one or two cams in the view?

 

[EngineerFreely]

Does this have a graphics card or onboard graphics?

Your iframe rate needs to be equal to the frame rate. Also, why 30FPS? Most folks run at 15FPS.

I suggest writing to the log file.

What happens if you only show one or two cams in the view?

The iFrame rate (is that the attached frame rate file?) When I adjust the camera to 15fps instead of 30fps, it goes right back to 30fps over a couple of seconds.

1 2 or 3 cameras, it does not matter. Its the same issue (#2 and #3 are black/bars).

 

[sebastiantombs]

Frame and iframe rates are set in the camera itself, not in Blue Iris. BI can only receive what a camera sends.