zmodo

Good day folks, let me first say I am a bit of a noob to the cameras and I am a Windows IT professional with 25 years under my belt. So now my issue, and please I know Zmodo stuff is bottom of the barrel but that's what I got to work with. I have a 4 ZP-IBH23-W wireless Cams. I setup two using...

I hadn't been using my Zmodo ZM-SH75D001-WA for a while, but fired it up recently and was excited to see it was still setup and working in my Tinycam settings. A few days later I logged into the Zmodo app and absent mindedly let it update the camera firmware to V7.4.1.26 (unfortunately don't...

Hello all, I was given an old Zmodo DVR camera package system awhile back and have it fully set up and running. I can access it over my network and using the Zviewer software from Zmodo. These cameras are analog and hardwired back to the provided DVR. Before receiving the setup, I have been...

I'm using BlueIris to monitor several video cameras including three from a Zmodo DVR. The cameras were working until I actually installed them on my house. Now, all three cameras become unusable throughout the day with garbled video. The problem is intermittent and doesn't occur at night when...

Hi all, I am running an 8 camera POE camera system by Zmodo (ZM- SS718), it looks like the NVR has completely failed (screen is completely blank, all I get is a green power LED) and I don't think that it is repairable. Can anyone give me advice on a replacement NVR? I'm in the uk and I am...

Hi All, Here is my dilemma, I have two IP Cameras. 1) ESCAM Peashooter QD520 - Example: rtsp://xxx.xxx.xxx.xxx.ddns.net:554//user=user&password=password&channel=1&stream=0.sdp 2) Zmodo ZM-SH-721 Ezcam - Example: rtsp://admin:password@xxx.xxx.xxx.xxx:10554/tcp/av0_0 Both video streams are...

Hi all... I recently acquired BI - have successfully connected several newer Zmodo 720P cameras. But I have several older cameras - ZMD-ISV-BFS23NM. Depending on camera configuration, I either get "no signal" or refused connection. Any suggestions on how to connect these older cameras...

I have had BI registered for one camera for a few weeks now. I only have one wireless Zmodo 720p camera. I started by a higher FPS rate (30fps) on both the camera and the BI software. I had many "no signal" errors. So I dropped the FPS to 15fps on both camera and BI. It worked better for a week...

I think I noticed somewhere in Blue Iris that you can send a refresh signal to your camera via watchdog settings. How can I determine if my camera will allow this? I have a Zmodo 720p wireless camera. I don't know the model number off hand, I can post it later. Any advice or info would be...