Customized Day/Night settings not saving

D

Defender574

Young grasshopper
Nov 11, 2024
38
13
USA
I've seen this talked about in a thread but couldn't hunt it down.

My two B54IR-ZE S3's were bouncing back and forth between modes at sunrise/sunset so I set a schedule for them under the customized scene tab in the GUI. I changed day to color and night to B/W and then placed the cams back on the Day/Night tab. I triple checked that there were no gaps in the time's but the cameras are not switching modes at the set times and still bouncing back and forth between modes.

Internet Explorer is being used, what am I doing wrong?
 
I dont use Day/Night for that and other reasons.

By switching back to Day/Night you're defeating the Schedule profile and allowing the camera to decide when to switch based on its light sensor.

I set my schedule times and leave it in Schedule profile as intended
 
bigredfish said:
I dont use Day/Night for that and other reasons.

By switching back to Day/Night you're defeating the Schedule profile and allowing the camera to decide when to switch based on its light sensor.

I set my schedule times and leave it in Schedule profile as intended
Click to expand...
So leave checked on the "Customized Scene" tab prior to exiting the GUI?
 
  • Like
Reactions: bigredfish
That’s what I do.
This allows me to set two completely different profiles (exposure etc) for day and night.

I have a few locations where I still leave Day/Night tab on Auto (still using the schedule profile however) to allow it to switch if I have a real dark area like my back porch where I have motion floods to kick it into color.
 
You must log in or register to reply here.
Top Bottom