Recent content by ym8016

  1. Y

    EZVIZ Smart marker box.

    Good day. I have two EZVIZ cameras, models CS-H8C and CS-H3C. I'm experiencing challenges removing the Smart marker box from both of them. I disabled it in the Phone app under settings, image settings, Smart Marker Box. I rebooted the cameras, but the box remains. Both cameras have updated...
  2. Y

    Failed to get Configuration settings Dahua

    Thank you.
  3. Y

    Failed to get Configuration settings Dahua

    The only way I can set it up to display on my NVR is through customised and the rstp protocol (rtsp:/192.168.1.178:554/h264)
  4. Y

    Failed to get Configuration settings Dahua

    Thank you for your response. I'm trying to setup MD recording only. I've configured the MD on the two cameras directly, but the recorder still does not record during MD. Is this a compatibily issue between the cameras and the recorder?
  5. Y

    Failed to get Configuration settings Dahua

    Good day. I have a Dahua DHI-XVR4104C recorder with two EZVIZ cameras connected to it. Model numbers of cameras is CS-H3C and CS-H8C. I managed to add them to the recorder and it displays fine. However when I attempt to configure motion detect, I get the error "Failed to get camera...
  6. Y

    IPNC DM368

    Try this : 8 Solutions: The Application Was Unable to Start Correctly (minitool.com)
  7. Y

    IPNC DM368

    Thank you
  8. Y

    IPNC DM368

    Any advise/assistance would be appreciated....
  9. Y

    IPNC DM368

    Good day. About 5 years ago I purchased an unknown brand IP Camera through AliExpress. Worked fine but recently it lost PTZ functionality. Need to install firmware but it is difficult to identify. NVR identifies it as IPNC DM368. This is the Web Interface info. Can anybody identify it? On the...
See more
Top Bottom