Recent content by tone308

Good to hear . That NVR also has show ip camera password . you can just the box and enter the nvr password and it will show all ip camera passwords. For future reference.

Just pulled on down and i cannot change them around. Mic must have to go at the top on these . All photos i have searched on the net show this camera to have the mic in the wrong location as it is where the memory card goes.

Ok just turned it around so mic is at the bottom and now the memory card slot is as well so its now upside down. The up indicator is now at the bottom. This is weird .These are 2 new hilook ipct260h-mu cameras purchased from a cctv supplier here in oz and both are facing the same way. Have...

Thanks heaps guys. I only noticed it after i had put it up .

Hi will it matter if the mic on a turret camera is facing up towards the top?

Hi no should be able to plug them into the back of the nvr . Then on the nvr go to camera search for cam should now see them coming up then click add camera you may need to then double click on the camera password and put in the camera old password .

Hi You may need to search for cameras then add them to NVR and enter the camera password.

Hi the NVR will do the AI features with hik camera's only . Wont work with the Dahua camera's

Ok so now you need to go to system settings , Then advanced settings , platform access mode, and click enable. Enter verification mode . That should give access from new version.

When first installing the software and installing the devices were it asks to add password for device in there is where there is a check box which need to be ticked to enable hik-connet on the new software.

viofo A119 have had them for a few years now and still going strong.

Just like to thank you for the post i have spent the last 6 hours trying to get a new camera to show on IVSM-4200 with no luck until i found your post. They don't make it simply any more. Lucky for forums like this and people like you it makes it possible. Followed your steps above all working...

Hi there. There a 2 versions of the new software 1 will allow access to config and the other can only view try downloading IVMS-4200ac.

Hi this is my first post as well. i had to do the same thing myself some time back . i did a factory reset on the nvr and for some reason it reset all the camera's passwords to the same as the new nvr password. Give that a try it may work.