Recent content by SpacecoastBill

No changes. It just started having a delayed (more than 30 seconds) response. I just replaced the contact end. The magnet still seems to work OK. Appears to be working as it should though.

Yes, it is on a zone extender.

No, wired contact, wood door.

I installed an 1864 and once it was up and running, everything worked great. Suddenly one zone is VERY slow to respond to the zone opening and closing. Its a door using a recessed remote. I can open the door and for the most part it responds instantly. But more often than not when I close...

I will try it..

I will try that. The wiring is good, it has continuity and resistance. When I remove the power, it opens. I tried connecting the wires and it does react as it should. I have on e resistor on each glassbreak (there are 2 of them, and 2 wires)...each to their own zone, and both C contacts...

The AC-100. I originally installed the 500 series but had the same thing happen. Im positive they are on the NC terminals.

I installed a new DSC 1864 system in my house. Everything works great with a songle exemption.... the glass break detectors. They constantly show an open zone. I have a resistor at the detector and at the panel end, the 5.6ohm resistor shows. Ive set the zone to a single EOL resistor. But...

So as clearly indicated, I didnt know where the setting was if it existed so how can I post the settings. I didnt ask anyone to post a detailed response, I simply asked if what I was looking for was possible. If soneone said yes and needed more information, I wold have done just that.

So I ask the community a question and the best you can do is RTFI?

Is there a way to have the video recordings overwrite over the oldest file? Im having to constantly go into the folders and delete videos

Yes, but then I found another problem. The PC1864 board was an international version and DLS was having none of it......

Its pk5500..... Typing on a phone...

I have a used dsc pk5100 keypad but it has old data on it. How do I default it?

I have a new DSC 1864 and Im using both 5108 Zone expanders as well as 5204 power supplies. My question is how would I wire a siren to use either the expander or power supply? I dont want to overdraw my main board....