Recent content by smcconnery

Alaister, All is good. I have it working. I think the issue was with a bad firmware. Downloaded and installed a fresh version and it works fine. Thanks again. You saved the camera from the landfill!

This is the file I uploaded Alastair, once again, many thanks. I looked at the file you sent me and the FF in location 0x64 does not seem to match with my camera type (1498 - DS-2CD2532F-IS) should I change this before proceeding? I am attaching the mtd6ro_mod file I ment to send before and...

You were correct in suggesting I use a 12 Volt power supply. I was able to complete all the steps in the process including uploading the new firmware 5.4.5. I can now see the camera using the SADP tool and change the ip address using password 12345. The issue I now have is that I cannot access...

I will see about getting a 12 volt power supply and disable the Window as well as Norton firewall and let you know the results. Thanks again.

I turned off Norton AV as well as Norton firewall and attempted using both the EN and CN dav files to no avail! any other suggestions?

The tftp shows TFTP server [192.0.0.128]initialized Nothing more is shown when the camera is powered on however every 20 seconds or so I the Link and 10/100 Mps lights flash on the switch for the port which the camera in connected to. I don't have a 12 volt power source for the camera however I...

I have a DS-2CD2532F-IS Camera that I purchased online from China. By mistake, I updated the firmware and now cannot communicate with the camera. The camera's infrared lights turn on so I am assuming it works. I downloaded all the files for the nine step approach to brick-fix the camera but am...

I have a DS-2CD2532F-IS Camera that I purchased online from China. By mistake, I updated the firmware and now cannot communicate with the camera. The camera's infrared lights turn on so I am assuming it works. I downloaded all the files for the nine step approach to brick-fix the camera but...