Recent content by RSYC

I do have the IP addresses for my cams. The wireless ones are: 192.168.254.149, 192.168.254.155, 192.168.254.126 and the wired ones are: 192.168.1.110 and 192.168.1.109

so here is what I get when i have the wireless cameras working VS when i have the POE IP cams working:

My 1 year of support ended on 4/21/22 so no updates after that. I will do my best to describe my net work map. From the ONT it goes into an Arris NVG468MQ Version: 9.3.0h7d91 Cable Modem(?). One of the outbound ethernet cabled goes up into my attic and into a POE switch which powers my 2 IP...

somewhere in my notes i had written down that my IP address was XXX.YYY.Z.AA, but after my system went offline, when i checked my IP adress it was now XXX.YYY.BBB.CC. If I change my network settings to that old address, I can't access the internet or those wireless cams, but I get the POE IP...

i don't think so....I'm guessing my computer doesn't have that capability as its an old refurbed Dell of some sort running an intel i7-6700 CPU @ 3.40 GHz with 16 GB ram

I'm not especially tech savvy, but with the help of many on here was able to get my system up and running for over a year. About 6 months ago something happened (no hardware changes) and all my cameras went to no signal. I tried going through the forum and troubleshooting using the search...

Can you ELI5? I suspect this is my problem as the app used to work just fine, then after a while it only works when i am on the Wi-Fi that the BI is connected to. When I’m on a different network or on cellular I get the “unable to make connection; check server address”. BTW, I did follow the...

Thanks! More than anything, even if it doesn’t work out it’s a way to work with the equipment so that I can slowly get to know how it works better as this is all very new to me

Sorry, I failed to tag…..

It’s proof of space crypto so its very low resources unlike proof of work or even proof of stake (its only a few reads occasionally off of some attached USB drives) and I am only running 3 cameras including a doorbell cam on 16 GB of RAM on an i7-6700 processor so the CPU ranges from 15%-20% RAM...

I’m not sure if this is even possible, but since the mailman stops at roughly the same spot everyday as opposed to all the other cars that just drive by, is there a way I can save that image so that DS can analyze the other images to see if its a match so that my alerts show if and when the mail...

Googled the info and I’LL wait till tonight to rollback since I am farming/mining crypto on my BI system

1. I’ll have to google how to rollback….. 2. yes, the object detection box did the trick 3. trigger sources: motion sensor, cameras digital input or motion alarm and trigger until reset is checked 4. You’ve been a God-send more than once in my BI journey. Thanks so much for the continued tech...

Running release 5.4.9.4 X64 (7/1/21). You are right, the cancelled alerts is full of everything that normally is shown in that section. I unchecked “Hide cancelled alerts on timeline and ’all alerts’”, and hopefully that will put things back the way they were. While I have your attention, how...