Recent content by paarlberg

In almost a week with both systems running, there have only been 2 no signal alarms on the camera. Previously I was getting 6 or more per day. Any thoughts?

Ok, well I just had 1 no signal on both systems for the cam in question. I am guessing it is a camera related issue or my config (imported settings into the other system). I will see if I can install one of the dahua cams on my other switch for testing. Then I can rule out the switch being the...

I have the other system up, but it is not any newer. I have it on the same vlan as the cameras to see if that helps. Oddly, since I got it up and running, the other instance has not had any drops. It has only been a few hours, so it is too early to tell yet.

I am on an older version 5.3.8.17. I have another box with BI on it with probably a newer version, maybe a few revisions higher. I can try that to see if it is there as well.

After further investigation, there are no issues with the cables and the switch ports show no errors. So this appears to be a config issue on the camera or in BI. I will swap out one of my older Hikvision cameras that are connected to the Cisco switch with the one I have on the short cable to...

One thing I forgot to mention. When I moved the camera to the new house, I had to re-IP it. To make things simpler, I added the old IP range to my SEC VLAN as a secondary range. This allowed me to connect to them without a bunch of headaches. I could then reach them and re-ip for the correct IP...

Ping statistics for 10.x.x.62: Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Minimum = 0ms, Maximum = 1ms, Average = 0ms Ping statistics for 10.x.x.61: Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip...

It was BI as well.

I have a Ryzen 9 3900x 12-core (24-thread) with 64GB of RAM. I have 3 drives, boot is NVMe, BI storage is on a 1TB SSD and I have another 500GB SSD for other duties. MSI motherboard. Using onboard NIC. All cams are static IPs on their own VLAN routed via my gateway. It is a 3-year-old...

No, I did not use grease on the outdoor connections. That being said, my other 9 don't have any either and not a single "no signal" among them. They have been installed for probably 8 years already.

They are protected from the elements and are corrosion-free. I will look at cabling being the issue since the one camera with the most drops was a new run. The cam in the pic I posted is a new short 5' premade patch cable.

Thanks, I am wondering if maybe there is some interference in the cabinet that has the switch. There is a UPS to the left. I might need to try some shielded cables to be sure.

I just moved several cameras from another property to my house. They all worked fine at the remote site (as far as I can tell). They are now connected to a TP-SG2210MP PoE switch. I am getting random "no signal" about 5-6 times a day. I have lowered the FPS, bw, etc to see if that is the...

I will take a look at the config next time I am there and lock it down.

My daughter picked up one the Armcrest to try and so far it is working well. Thanks