I purchased an IPC-HDBW5442E-ZE-OPAT from Empiretecandy - thanks Andy.
I initialized it and changed the IP settings to DHCP and can login to the Web3 interface.
However, the PTZ tab is missing from the main screen - what do I need to do to enable PTZ? (Blue Iris cannot exercise PTZ control either).
Originally I was going to do that using this Raceway Roll but then I calculated how much the raceway would expand when going from 32 to 110 degrees and it was 4+ inches in a 16' run therefore it would buckle. That's why I switched to running under the eave using clips (then painted) and then...
I am running the CAT5 under the eaves on the left then need to continue running the cable all the way to the right side (not shown) of the house. Rather than continue under the eave usinging clips I'd rather hide it by tucking it under the gutter. The second image shows the gap between the...
I need to run about 20' of cat5 between the gutter and the house wall (stucco). The gap is about 1/2" so I'm looking for something to keep the cable in place. I thought about repurposing the 1/4" widest co clips
installed an eval version of BI and added one camera. The stream had a “Blue Iris evaluation version” watermark across the middle. I understand that and it was small enough not to obscure the image. But after an hour or so that watermark was replaced by “a1u” which fills the entire image...