Recent content by krassyg

  1. K

    Event Center not working on new 5.0 NVR firmware

    Any of you guys tried the new 5.0 NVR firmware on Hikvision? Can't view the events in the event center event though they are logged in. Anything that I am missing when setting them up?
  2. K

    Running shielded Cat6 behind gutter downspouts

    My bad; I forgot to mention that I AM using an outdoor rated, shielded and white cat6 cable. No attic and not possible to run the cables in the walls. I am running a few locations inside the soffit but then I still have to come down into the basement. I need to hide the cable since this is an...
  3. K

    Running shielded Cat6 behind gutter downspouts

    I am planning to hide the camera cables behind the gutters downspouts and secure them with white cable ties. Curious if that is allowed since the downspouts are potential lighting strike pathways. The NVR will be connected to a surge protector/UPS; will tie the shields directly to the rack...
  4. K

    Soffit Vent removal for cat6 run

    The soffit vent came out easy; putting it back was a bit tricky but it worked out fine.
  5. K

    Soffit Vent removal for cat6 run

    I dont see any nail markings securing the vent; I should be able to just pull it out:
  6. K

    Soffit Vent removal for cat6 run

    I am not touching the soffit; just thinking how hard it is to remote a small piece of the soffit vent and fish the wires from one end of the soffit to the other. Planning to hide the wires behind the gutter downspout.
  7. K

    Soffit Vent removal for cat6 run

    Thats the plan; just not sure how easy it is to remove the soffit vents without breaking them.
  8. K

    Soffit Vent removal for cat6 run

    1st floor; front would be about ~10-12'; from the back ~8-10" since there is a deck. Basement is tiles grid throughout. The cables for the rear cameras are going below the deck into the basement; the ones in the front of the house I am not sure yet. I can route them behind the house and below...
  9. K

    Soffit Vent removal for cat6 run

    Have to drop 8 cameras to the basement from bellow the deck; no attic. Planning to just staple white outdoor rated cat6 to the white corners and go down; shouldn't look too bad. Just in case I have to go sideways; how hard it is to remove the soffit vent if I want to hide the cable. I can also...
  10. K

    Wireless door Sensor to Wired Alarm input

    Thank you; that's what my local ADI shop suggested as well.
  11. K

    Wireless door Sensor to Wired Alarm input

    I have a video intercom with two alarm inputs for wired door sensors. I can't run wires to these two doors; do they make a wireless door sensor with a receiver and a relay?
  12. K

    Gooseneck cable flashing for roof penetration.

    Is that a legit company? The picture is from their web site; just never hear of them.
  13. K

    Gooseneck cable flashing for roof penetration.

    Need to run cables through the roof for cameras; do you guys know who sells something like this?
  14. K

    Hikvision Event Playback without iVMS-4200

    Solved, the setting was buried in the NVR Event settings, Linkage Method "Notify Surveillance Center".
  15. K

    Hikvision Event Playback without iVMS-4200

    Is there a way to do event playback outside IVMS-4200? Don't see it in Hik-Connect or in the browser, just want to make sure I am not missing some buried option in the settings that will turn it on.
See more
Top Bottom