Recent content by IPCamer

I guess that firmware is a custom specific release, normal releases are using zeros at the position of "1CKA" , see custom firmware screenshot below Maybe you found the "jackpot" firmware where they fixed the IVS push? It seems you are the only one with a 4.002.xxxxxx firmware that has IVS...

@Bumworms I have reacted in this tread , i also did not get the push notifications from IVS. In my setup I do not use P2P and added my NVR as a local IP to DMSS. So still using one of the first V4 firmware release and I do receive all MD and AI events as a push message on my phone ( if enabled...

Will send you a PM with the specific firmware because it is not available on the internet.

To make a summarization of the confusion that is created by Dahau to use the same type number DH-SD22204T-GN for units that have different hardware revision, in this case the size of eeproms to store the firmware. As mention by @Dave Lonsdale and @TVT73 So cameras made before 2017-2 will have...

Alright, could you tell me already what the file size of that firmware (****.bin) file is?

Could you sent me the firmware file as well, i am curios if this is a version that does work on my old camera. Thx.

@xxxlolo Can you check for a setting called "disarming": Disarming should be disabled, For the push notification, Mobile Push Notifications should be enabled. Screens can look different on your firmware version , but just check for the main items.

@xxxlolo See this tread for same issue. Try to use a firmware version V4.001.xxxx !

@CameraYager What browser do you use? Can you use IE11 browser or Pale Moon 32bit, see this topic/post.

@Pavel-V When running PSS ( same version) with only 5 devices configured and no Live views , it uses almost the same amount of data as in your situation: So probably as designed......

@Domparisi I have encountered the same issue on the NVR4216-I when installing the latest firmware DH_NVR4XXX-I_MultiLang_V4.002.0000000.1.R.220211. No IVS notification on DMSS App anymore! Went one version back to DH_NVR4XXX-I_MultiLang_V4.002.0000000.0.R.210811 , also no IVS notifications...

@EMPIRETECANDY Thank you for your feedback. For the P2P function, it will be set back to enabled every time you will do a reboot (also a scheduled reboot), it is not related to set settings to "default" or "factory default".H Sorry , will verify again. For now it seems to work correctly...

@EMPIRETECANDY Some questions about the new firmware "empiretech-5442-smart-ir-general_ipc-hx5xxx-volt_multilang_np_stream3_v2-840-15og008-0-r-220218-bin": 1. Is this security issue also resolved in this firmware ? 2. Do you need to perform a factory reset after installing this firmware ? 3...

@Cctvrole Did you test your speaker with open input, the plug not connected, or already connected to your nvr? What if you short the input , so directly connect the yellow and white wire together, is the hum then less or gone? If not, then the power supply used, is not clean enough on the...

What is the type number of the camera? Does it have external alarm wires that are making a short? Did you already pressed the reset button for at least 10sec?