Hi everyone,
I have been looking for a new firmware because 5.4.8 drives me crazy when I want to set time for patrol pause to less than freaking 15 seconds. I found out on UK/Ireland hikvision website that there is a new firmware 5.5.0 and they mention changing time from 15 to 5 seconds but...
The Linkage method on both cameras is the same.
The network config is the same and they both dont have anything as defauly gateway. The IP is assigned by the NVR, virtual host is enabled.
Any other ideas??
Hi,
So I have NVR DS-7616NI-E2 / 8P and 2 IP PTZ cameras connected. When I go to Event-Basic Event-Motion tab, there is Channel No. where I have Camera 1 and Camera 2. I have exactly same settings for motion detection for both cameras, meaning that motion detection is enabled + dynamic...
Hello,
So I just bought a new NVR and I was very excited so I have decided to upgrade it. Downloaded firmware (now I know that I used firmware NI instead of N which caused bricked NVR) from hikvision.com and now, it is bricked=stuck at loading page and beeping for about 20 seconds and then it...