I have resolved the issue. I had Stream Encryption enabled and I had forgot to add a Route for the NVR Network Card IP to point to my default gateway. Thanks.
Hello, I seem to have a problem with this RTSP stream again my stream should be rtsp:/username:password@192.168.0.245:554/Streaming/Channels/102 but this is not working. I have my camera PoE cables directly connected to the NVR. I will upload screenshots of my current settings and hopefully...
I had a bad copy and paste. My URL is rtsp:/username:password@192.168.0.245:554/ch1/main/av_stream
My cameras are connected via the NVR PoE ports. Which LAN IP do I point to? The Internal IP address or the standard? I haven't used this Static Routing before, though I do know of it. Can you...
Due to some works that needed to be done at my home, my Router was offline for a couple of days and this has caused a problem with several settings I had setup for Homebridge Camera Ffmpeg. My streaming URL's no longer work. I have attampted to go back and fill in the missing pieces, but so far...
I have been able to get to the individual cameras Video settings, fantastic. The Ffmpeg Plugin is still not streaming my RTSP streams. I have a bit more work on that to do.
The only other issue I have is the remote platform setup. Hikvision keeps telling me the access is offline. I am able to...
I followed the link you provided and it worked. I then added the rtsp stream url into the custom protocol section. It does work on VLC. The video settings I need to adjust are in the Video/Audio section on the DVR. But I cannot edit much settings for the video parameters on the DVR. The RTSP...
So far so good. I can see individual networks. Everything seems to be set as the post explained. I do have RTSP streams working again. There is just one small issue. I am not able to edit any of the Video settings. I need to set it so it is in H.264, otherwise Ffmpeg don't like it and there is...
I have done the reset. My DVR IP has changed and the IP cameras. I did attempt to manually adjust the IP addresses of 2 cameras and the system don't like it. I think I might need to initialise the cameras using SADP, but cannot do that while they are connected the DVR. I am looking up some...
Unfortunately no. We have narrowed down the issue, I just need the solution to solve it. I will be doing some tests shortly. I believe I'm going to need to manually configure the cameras individually. I have done that with a network switch, not sure how good it will work within the DVR.
I have tried that and strangely, I am not getting any kind of response from VLC. I am thinking it might be a good idea to factory reset it and setup again. I'm wondering if there might be some conflictions that we cannot see. I don't remember it being this difficult to setup originally.
All my devices us the same Subnet which is 255.255.255.0. The IP address of the PC I am working on is 192.168.0.71. I have attached a screenshot of my DVR Network screen for you. Thanks