Recent content by car_wash_guy

  1. C

    Lost video on LTS CMIP1142W-28 - Suggestions?

    Figures - I'm leaving for three weeks today and I lose video on one of the most critical cameras on my system. Not sure if there is any correlation, but yesterday I set up an old iPad with ivms-4500 for my employee to monitor while off site, and that is when I started noticing the issue. At...
  2. C

    What cable for this camera situation ( partial aerial run)?

    OK. Thanks for the info. I think I'm leaning back to my original plan - running the aerial drop. Mainly because I think I'm going to run 2 lines for 2 separate cameras out there. One a dedicated LPC cam, and the other for general surveillance of the location.
  3. C

    What cable for this camera situation ( partial aerial run)?

    Would 2 of these work? https://www.amazon.com/dp/B004EHSV4W?tag=ipctk-20
  4. C

    What cable for this camera situation ( partial aerial run)?

    Yes - I might have gotten the idea from one of your posts. I remember searching and a member here had stated he had done multiple 400+' runs with no issues. I think he also said he used the Shireen for all his runs. Was that you?
  5. C

    What cable for this camera situation ( partial aerial run)?

    No go on using the conduit to the sign. It has wires for my pole lights un there too. What about seeing up a wireless bridge? I'd be looking at a 150' distance from cam to building. This is the way the old cam was set up but, granted the cam/system was almost 10 years old, I felt the pic...
  6. C

    Dedicated License Plate Cam project

    This thread has been a great read. I just ordered a Huisin v2 for my LPC cam for one of my business locations. I look forward to sharing my experiences.
  7. C

    What cable for this camera situation ( partial aerial run)?

    Thanks nayr. I just need to decide if I should run it this way ( more involved since I'll have to bury it and set up the suspension system and run conduit down the light pole) or just sacrifice my small illuminated entrance sign ( It's only ~ 5' from my camera location) and use it's conduit to...
  8. C

    What cable for this camera situation ( partial aerial run)?

    I have a camera going in at the entrance to one of my properties. Total cable length is ~ 300'. My issue is I need to run part of it aerially from my building, across the parking lot, to a light pole. Then down the pole and buried to the camera. I was thinking either Shireen or Ubiquiti...
  9. C

    POE switch and POE injectors. Questions.

    Thanks guys. Hooked up the injector and it's running.
  10. C

    POE switch and POE injectors. Questions.

    These are the PTZs I'm installing: http://www.ltsecurityinc.com/ip-camera/platinum-ip-network-ptz-camera-ptzip512x20ir.html
  11. C

    POE switch and POE injectors. Questions.

    Thanks fenderman. Do you think I need the injector? Here is the switch I'm running: http://www.ltsecurityinc.com/poe-switch-poe-sw2402.html It's 802.3at/af and 30w per port. Thanks
  12. C

    POE switch and POE injectors. Questions.

    Question about injectors and a switch. Coming up on installing my PTZ's and had some questions. It was suggested that "I run them (injectors) instead of going directly to the switch". 1. I would assume that the injectors are placed between the POE switch and the PTZ(in this case) camera...
  13. C

    System config question

    Ok. I have a 24 port switch and 16 cameras, so that's what I'll do. Basically, should the NVR be connected to the router or switch? This is the switch I'm using : http://www.ltsecurityinc.com/more/po...sw2402l-f.html It has the 24 PoE Ports at 10/100 Mbps + 2 Gigabit Uplink. I assume I plug...
  14. C

    System config question

    Not sure the correct way to set up my system, and what, if any, would be the benefits/drawbacks of each? How should I setup the router, switch and NVR? NVR Cable Modem---------> Router------<...
  15. C

    Am I wiring my connectors properly?

    Thank you sir - I almost lost it when I thought I was doing it incorrectly.
See more
Top Bottom