I too did the upgrade and was able to re-flash from batchconfig. Here are the options that worked for me - complete restoration DID NOT WORK and reported that upgrade failed.
Who knows where to get the 220530 version that we were on before? I'm fine if it's Hikvision.
I ordered 2 C800 and got one old model (all metal, regular old mounting base size) and one new one (more plasticky base, smaller mounting base).
Are folks keeping the new model or sending it back? The seller on Amazon has one picture in their listing that says "random model will be sent out...
We did create an ezviz acct for spouse but sharing with that email from Hik-connect said account didn’t exist. It’s like Hik-connect no longer knows about new ezviz accounts.
Did ezviz change something recently (like in the past week) that makes it so a Hik-Connect account can’t share to a new Ezviz account? I linked my ezviz-branded/firmware camera to Hik-Connect so that I could get it into Hik i2p/p2p/platform (all my other cams are Hik so iVMS will now show all...
So is version 5.1.6 vulnerable? I have a DS-2CD2332-I and from this article (Hikvision Patches Backdoor in IP Cameras ) it says versions 2.0 to 5.4.0 are vulnerable. But CERT says 5.2.0 to 5.4.0 (Hikvision Cameras | ICS-CERT). Did the article just leave off the "5." Before the 2.0?
Buy a RPi if your unraid doesn't support quotas. Then setup different users for each camera and share out via smb. I'm doing something similar but have separate 75GB partitions for each camera on a USB drive connected to my RPi
I was assuming you were building, I'd go ahead and run cables up there in case you decide the locations were wrong and you want to move them. Cat 5e or 6 would be fine.
Attic chase or conduit, it's essentially a flex tube running from the attic all the way down to the crawl space so I can...
I second the DS-2CD2332-I. I have 4 of them (US-based versions, bought of Amazon) with similar locations as you. I'm using 5.1.6 and taking advantage of multiple plane traversal areas to minimize false alarms. I mount them under the eaves and have CAT6 running to those locations. Make sure you...
Any idea how to get iVMS to show the motion detection areas - like these?
I have figured out how to have plane traversal areas showing (but only one one of my machines); NO idea how I got them enabled - but can't figure out how to get the motion detection areas to show when I move my cam to...
Do you have "Enable Dynamic Analysis" on? If I'm covering a long driveway that can quickly go from full sun to shade, would you recommend doing several small areas vs. just a few large? I'll turn off plane traversal and give it a shot; I'd love to be able to go to 5.2.x but been tied down by...