can I trigger IVS Rule via Http Command ?

[ricklndn]

I'm trying to figure out what command will trigger an IVS Rule ? anything thoughts?

 

[ricklndn]

bump

 

[Tinman]

Here is the API manual, but not sure if you can trigger an IVS rule.

Post in thread 'latest Version of DAHUA HTTP API FOR IPC Documentation ??'

Feb 22, 2024

Dumb offtopic question, but is this applicable to NVRs? The requests just return me 404 Not Found on couple of NVRs I have, but works fine for XVR or IPC itself.

A thing to make this post a less offtopic

• zaqik

• 

 

[Alaska Country]

Why do you want to trigger an IVS rule?

 

[ricklndn]

Why do you want to trigger an IVS rule?

I get a lot of bugs, spiders, camera always goes off.. now I have a motion sensor that works perfectly, it's programed into my Hubitat, it's able to send commands to the camera when motion is detected. This is why I was asking...

 

[Alaska Country]

Also use IVS with very few false triggers, but have camera smart motion detection turned off. No flies, spiders, falling leaves or shadow false triggers on BI.

In the BI help file, around page 280, there are some Admin Commands that could be of use.

However, with Hubitat one could use the below API to perhaps turn the camera on and then off with a Hubitat delay for the off function triggered by your MS.

 

[ricklndn]

Also use IVS with very few false triggers, but have camera smart motion detection turned off. No flies, spiders, falling leaves or shadow false triggers on BI.

In the BI help file, around page 280, there are some Admin Commands that could be of use.

However, with Hubitat one could use the below API to perhaps turn the camera on and then off with a Hubitat delay for the off function triggered by your MS.

View attachment 224799

Yes, I'm already aware of this, but still trying to trigger the camera ivs, this way I can get a notification on the Dmss