manually disable motion detection - auto enable it after specific time

[oparudi]

Hello guys,

is that possible? I could not figure it out. The reason is that we want to disable it randomly (when we are at the observed site) and do not have to re-enable it when we leave because we record only on motion detection.

thx

 

[fenderman]

Hello guys,

is that possible? I could not figure it out. The reason is that we want to disable it randomly (when we are at the observed site) and do not have to re-enable it when we leave because we record only on motion detection.

thx

Yes set two profiles... Then temporarily change it to the profile that has alerts disabled... You can set the length of the temporary hold

 

[oparudi]

How can I set this length?

 

[anijet]

Settings - Profiles - Temp Time

Help:
"Each profile may be assigned a time to remain temporarily active before returning to the
normally active profile (as defined by a schedule, see below). You may select that the
temporary state is immediately cancelled when a camera is triggered."

 

[oparudi]

Ahh, got it. Thanks a lot!