Upgraded to 5.3.0 Unable to access cam remotely when connected via wifi

[klasipca]

I have hacked 2432 Chinese cam which was running 5.2.5 firmware, I decided to test waters with 5.3.0. Upgrade went fine. I did a complete reset just in case and reconfigured it the same way and discovered the cam was not accessible remotely. It worked only via local IP. When I hooked it up directly to router it worked fine remotely and locally. Another thing I noticed that it shows 54 Mbps instead of 150 Mbps on my other 2432 cams running 5.2.5. So, did Hikvision cripple wifi somehow? Why wouldn't it connect remotely? Is this some known issue?

 

[whoslooking]

Yes it's known and you should have read all about it here first, but what ever.

To fix it just use the downgrader in the sticky section.

 

[klasipca]

Yes it's known and you should have read all about it here first, but what ever.

To fix it just use the downgrader in the sticky section.

I have not found anything in that regard, perhaps it was discussed a while ago. Nothing in your downgrader post either.