So i've more or less narrowed down what I want to start out with, but just need a quick "gut check" to make sure I am not missing anything. (Recommendations gathered from "Least Damaging" installation method? , thanks everyone for your input there)
Tools/Cables/Etc:
Crimper: Klein Tools VDV226-110
Cable(I've heard cable matters/monoprice are good options): Cable Matters Bulk Cable (I wish they sold 500ft, if anyone knows of a good amazon link for 500ft spools (it's better to buy 2 smaller spools and pull them both at the same time i've found(
Cat6 Plugs: Cat6 Pass Through Plugs)
I have Strain Relief Boots (From Cable Matters), as well as zip-ties and cable tester. I also have a 150w switch: Amazon.com: Ubiquiti US-16-150W Networks Networks UniFi Switch, 16 Port,White: Computers & Accessories
I guess there is no point using a patch panel in this case (I have a small network rack/case). It makes more sense to just run it back directly to the switch right? (I previously had a patch panel at my last house, but I was wiring up cat6 cable ports around the house.
Cameras:
Trying to decide between these 3 cameras (Trying to stay around the 200 dollar range):
I am looking for a 4MP Dahua either way for ~200 bucks so if anyone has other options let me know.
Sidenote: I do have normal cat6 plugs but they are not pass through. They worked ok but were more difficult. From my understanding pass through connectors are much easier, and it seems like that klein tools crimper works well with it. Any advice on this? Or does it "not really matter"
Thanks!
Tools/Cables/Etc:
Crimper: Klein Tools VDV226-110
Cable(I've heard cable matters/monoprice are good options): Cable Matters Bulk Cable (I wish they sold 500ft, if anyone knows of a good amazon link for 500ft spools (it's better to buy 2 smaller spools and pull them both at the same time i've found(
Cat6 Plugs: Cat6 Pass Through Plugs)
I have Strain Relief Boots (From Cable Matters), as well as zip-ties and cable tester. I also have a 150w switch: Amazon.com: Ubiquiti US-16-150W Networks Networks UniFi Switch, 16 Port,White: Computers & Accessories
I guess there is no point using a patch panel in this case (I have a small network rack/case). It makes more sense to just run it back directly to the switch right? (I previously had a patch panel at my last house, but I was wiring up cat6 cable ports around the house.
Cameras:
Trying to decide between these 3 cameras (Trying to stay around the 200 dollar range):
- Amazon.com : EmpireTech IPC-T5442T-ZE 4MP IR Vari-Focal Eyeball Starlight IP Camera Support POE and ePOE White
- Amazon.com : Loryta IPC-B5442E-ZE 4MP Starlight+ WDR IR Bullet AI Network Camera 2.7mm ~12mm Motorized Lens English Version
- Amazon.com : Loryta IPC-B5442E-Z4E 4MP Starlight+ WDR IR 8mm–32mm Motorized Lens Bullet AI Network Camera English Version
I am looking for a 4MP Dahua either way for ~200 bucks so if anyone has other options let me know.
Sidenote: I do have normal cat6 plugs but they are not pass through. They worked ok but were more difficult. From my understanding pass through connectors are much easier, and it seems like that klein tools crimper works well with it. Any advice on this? Or does it "not really matter"
Thanks!
As an Amazon Associate IPCamTalk earns from qualifying purchases.