Replacing the set screw/tab on Hikvision Turret

[Intergrity]

Ended up with a few cameras missing the set screws and clips to hold the turret on to the base. Just wondering if anyone had ran in to this predicament before?

I'm sure I can figure out a way to rig them together, but was hoping someone already knew the screw size? Figured I could use the clips off a cage nut for the tab.

 

[fullboogie]

I don't offhand but they are terrible. Take the base into an Ace Hardware and start trying out small machine screws.

 

[Intergrity]

M3 x 6mm screws and M3 x 10mm square washers did the trick. Some modification needed on the washers though.

Couldnt find them locally, so amazon'd both. Hope this helps someone someday