Hi guys,
I've bricked my cam ;-(
HWID=IPC-HDBW4631R-ZS-27135
I've managed to get into U-Boot via serial interface, however no matter what I set, the Ehternet won't activate.
e.g. The Ethernet lights are not flashing nor green/yellow -- dead
Is there a way to re-flash firmware via serial interface?
Is there a way to do a sort of "ifup eth0"
If I let the cam to boot the existing fw, I get to dsh prompt with very limited command set.
The "shell" will ask for Domain accounts:
typing 888888 will render QR code and ask for code validation , (I am now left with 3 re-tries)
Any advice, pointer is welcome.
Thank you,
N.
I've bricked my cam ;-(
HWID=IPC-HDBW4631R-ZS-27135
I've managed to get into U-Boot via serial interface, however no matter what I set, the Ehternet won't activate.
e.g. The Ethernet lights are not flashing nor green/yellow -- dead
Is there a way to re-flash firmware via serial interface?
Is there a way to do a sort of "ifup eth0"
If I let the cam to boot the existing fw, I get to dsh prompt with very limited command set.
The "shell" will ask for Domain accounts:
typing 888888 will render QR code and ask for code validation , (I am now left with 3 re-tries)
Any advice, pointer is welcome.
Thank you,
N.