Need help setting up port forwarding

[tn2015]

I have Zmodo ZP-KE1H04-S NVR sPoE Security System with 4 HD 720P.

I have ZSight on tablet. Zviewer on PC (both are on same network). I can see the cameras on them at home fine.

I tried to port forwarding on my router so I can see them on net from remote access (work/away). The instruction seemed pretty straight forward but when tested: it said Closed.


Any recommend where to look at?. Thanks

I have router TP-Link running OpenWR

ISP: Time Waner Cable, Motorola modem.

 

[fenderman]

Welcome to the forum...post screenshots of your port forward settings -both in your router and from the zmodo interface.

 

[tn2015]

Followed Zmodo instruction, I check DHCP to get the IP, Subnet, Gateway then un-check it. UNPN I keep in on

Do I need to fill in DDNS

In router, I tried 0080, 80. then 8080 like instruction said but no luck

 

[fenderman]

You need to change the web port on the dvr to 8080 as well...
Disable upnp

 

[tn2015]

Disable UPNP in router and Zmodo?

Edit: Tried 8080 after changed on NVR, no luck

Tried 80 after changed on both, still no luck.

 

[fenderman]

Both...

 

[tn2015]

Any helps on this?

 

[fenderman]

Have you tried logging in from a remote location or with your cell phone on cellular data?

Sent via Taptalk

 

[tn2015]

I did and no luck.

One thing though, I typed :80 after the external IP address: http://xx.xxx.xxx.xx:80, but when I hit enter, the :80 disappeared. Is it supposed to be like that?

 

[fenderman]

I did and no luck.

One thing though, I typed :80 after the external IP address: http://xx.xxx.xxx.xx:80, but when I hit enter, the :80 disappeared. Is it supposed to be like that?

80 is the port by default so it disappears...as stated earlier you need to change the port to 8585 and the type :8585
Dont use port 80, its blocked by many isp's

 

[jasoncmt24]

Did you allow the open the ports in the router firewall?

 

[tn2015]

Did you allow the open the ports in the router firewall?

I see my IP camera in the Inbound rules. Should I create new rules or change new rule for IP Cam?

 

[tn2015]

80 is the port by default so it disappears...as stated earlier you need to change the port to 8585 and the type :8585
Dont use port 80, its blocked by many isp's

Tried on 8585 and no luck.

I even go to control panel - window firewall - inbound rule and set new rules but still no.

 

[fenderman]

Tried on 8585 and no luck.

I even go to control panel - window firewall - inbound rule and set new rules but still no.

Did you make the proper changes in the router port forward settings to reflect the new port?

 

[tn2015]

Did you make the proper changes in the router port forward settings to reflect the new port?

Yes, every time I changed the port number, I changed everything (Zmodo, router, window firewall)

 

[fenderman]

Yes, every time I changed the port number, I changed everything (Zmodo, router, window firewall)

If you would like i can do a teamviewer session tonight to help you.