Just installed Archer C7 router.. now IP cams are not connecting to network

[Rickalo]

Just installed a new Archer C7 Wireless router, replacing my Linksys E4200 router... I have 6 wireless IP cameras I monitor using my iSpy program. With the E4200, I could do a scan of my home network, and ID all the cameras, and get them setup to view when PC was on...

Since I installed the Archer C7, I cannot see these wireless IP cameras to set them up again. I am figuring there's some setting I have incorrectly set on the Archer router... anyone have any suggestions on what I should check? I use the program Advanced IP Scanner software to identify all IP devices connected... and none of the cameras show now...

Thanks in advance for your help!!

 

[bob2701]

Check your LAN address, the Linksys E4200 router is default 192.168.1.xxx and the Archer C7 defaults to 192.168.0.xxx.

 

[Rickalo]

Thanks... I took a couple of the cameras down, connected them directly to the Archer, and re-identified new IP addresses with .0. instead of .1.

When I reinstalled them outside, (closer to my Linksys bridged router, they wouldn't reconnect.. looks like I need to do some work with the bridged router to make this work...

Appreciate your input!