Dahua DH-SD59430U-HNI Auto tracking help

[WTFG]

I have been trying to tweak my auto tracking,
I have 4 set cameras sending my 59430U to presets.
When the ptz goes to the preset it stays there, till another one of the stationary cameras trips and it goes to that preset.
I would like it to go back to a home position after, but it stays at the last stationary camera trip.
Any ideas?
It doesn't seem like there is a home position, I have 7 presets set on the 59430U.

 

[weigle2]

Make sure you have this set correctly in you SETTINGS > PTZ section:

 

[tibimakai]

Thanks for this, I will have to do this on mine as well.

 

[bradner]

Can also try the "Time Task" settings too. I've used both (Time Task & Idle Motion) successfully to return to "Home" or a certain preset after a set number of minutes/seconds.

 

[WTFG]

Thanks weigle2 and bradner I didn't know about those settings, I will try .

 

[WTFG]

The idle Motion didn't work for me, but the Time Task did work !
Seems like the idle motion should have, strange.

 

[Arjun]

I had to go with Time Task as well to make things work. Not sure why Idle Motions works for some but not for others

The idle Motion didn't work for me, but the Time Task did work !
Seems like the idle motion should have, strange.

 

[bradner]

I had to go with Time Task as well to make things work. Not sure why Idle Motions works for some but not for others

Funny because Time Task started acting up on me for no reason and I had to switch to Idle Motion

 

[Arjun]

This firmware is playing with our minds

Funny because Time Task started acting up on me for no reason and I had to switch to Idle Motion