Camera mount on eves

[pal251]

Installing some colorvu or nitecolor cameras with junction boxes on a soffit or eve. Would like it to be a bit lower to prevent light reflection. Any ideas on how to lower the box. Has to look nice, the in laws are picky as hell

 

[coney27]

This is my ColorVu with no junction box. I only have IR feedback due to the camera's right side facing the soffit which is above a door that I wanted to have covered by the cam

 

[mat200]

This is my ColorVu with no junction box. I only have IR feedback due to the camera's right side facing the soffit which is above a door that I wanted to have covered by the cam

hi @coney27

How much lower do you want to make it?

If only 1-2" I would cut a section of wood from a 2"x6", drill a hole in the middle for the cables to pass through, paint it and use it as a mounting "block" - but that only drops the camera down 1.5"

 

[coney27]

hi @coney27

How much lower do you want to make it?

If only 1-2" I would cut a section of wood from a 2"x6", drill a hole in the middle for the cables to pass through, paint it and use it as a mounting "block" - but that only drops the camera down 1.5"

I'm satisfied with my mount. I was explaining to @pal251 I only have some slight IR feedback and that's due to deciding that I wanted the camera covering a door. If I had not covered the door IR feedback would be a non issue. Thanks for the advice though