Annke C800 Firmware 2021

[hugh2200]

I upgraded to the latest firmware and Zone#1 Motion Area under Events. Drawing setup Will does not retain boundary lines. However, Zone #2 or #3 will retain the setting as normal. I didn`t notice this until I upgraded. This only happens when NVR or Cameras are rebooted.
amera reboots!

 

[watchful_ip]

Did you reset camera to factory defaults after upgrade?

 

[hugh2200]

Did you reset camera to factory defaults after upgrade?

Yes, I reset defaults and rebuilt zones. I wish I could roll back the firmware to verify if it is related to upgrading.