Amcrest AD410

B

blitzkrieg3002

n3wb
Dec 9, 2016
7
0
Got an Amcrest AD410 up and running yesterday with Blue iris. Got Main and Substream setup. I've Been playing around with it. I'm using ONVIF alerts sent from the AD410 Motion Sensor Triggers to blue iris. It doesn't appear however that the Human detection/triggers that the AD410 picks up will send ONVIF alerts to Blue iris. is this normal?

are there any other tips for setting up the Amcrest with blue iris? Was hoping to get the human alerts to work but maybe it doesn't work with this camera? Also doesn't appear to have any setting to setup the I-Frame. i'm at 15fps / 0.5 has perfect 5ghz signal with an AP literally 15 feet from it. is it recommended to use H.264, H.264B or H.264H?
 
To be honest the AD410 and the AD110 should not be changed from any 3rd party software or hardware. To be honest not even from the Amcrest Software that it says things can be changed using the Amcrest Ip config tools but if you do it will make the camera unstable and do a Constant Reboot. Then you will need to remove the camera from the mount to Reset it.. That is a task of its own...

When you connect the camera to Blue Iris. It would be best to just let it work as it will without making any changes that could cause the camera to fail. There are some that have reported Fail to the point that a reset didn't even cure. I would tread with caution.
 
You must log in or register to reply here.
Top Bottom