I just updated to 5.4.4.7 and I notice on my alert clips that motion is highlighted regardless of my setting and that the clips from a camera where I have a motion zone defined only shows the detection zone in the clip. The rest is blacked out.
5.4.4.7 motion overlays/motion zones problems
- Thread starter drjjr
- Start date
Duh...figured it out...Somewhere I checked the "test run video through motion detector" and it has been doing that since then.
beepsilver
Getting comfortable
Test run video is useful at times, but I like to see the whole field of view when using it. I use zone G on all my zone setups (encompassing the entire field of view) so when/if I do use the test run, I see the whole picture. I don't use zone G for any triggering.