Search results

I've had BI up for a couple of years now with 15 h.264 and h.265 cameras, and I bought an Annke 5MP to replace one of the older h.264 models. I ran their SADP software network camera discovery tool and it said the camera was set to port 192.168.0.167 (attachment #1). I don't think I have...

I bought an Annke refurbed 5MP camera, but it came with no documentation or software, and BlueIris' Find/Inspect doesn't see it (I've actually never had find/inspect work without putting the address in the top; it inspects, but can't find <grin>). I'm assuming in the refurb process they reset...

I rebooted and this started, so it's something I've changed in the last week or so that needed the reboot to activate. It happens on replay of clips at main stream resolution, and I don't think it's related to CPU because my CPU runs only about 9%-14%, and I use about 1.2 GB RAM of 8. If I...

I have 15 cameras so though I have an I7 running at 3.6, CPU usage is not my friend so I'm looking for ways to improve. My Sony 3MP cameras have software with them where I can and have set up motion detection areas in the camera, so putting that work in the camera instead of on BI sounds smart...

I'm trying to run Blue Iris on an Athlon dual core processor at 2.7 GHZ with 8 GB RAM and ATI Radeon 3200 video? I'm clicking on Direct to Disk recording, but when I add the 5th camera everything grinds to a stop. Blue Iris help basically told me to read the F'n manual on CPU reduction. Most of...

As an introduction, I have a Dahua 16-ch POE NVR with 14 Sony 3MP cameras plugged in. I could never get the NVR to initialize more than 12 at a time; I'd get a timeout error. Some say it's bandwidth; that the cameras are 3MP and the Dahua will only init 16 when they're 2MP. Could be, but I'm not...