Search results

I have tried your steps big red but i continuously get one camera with a red status and not connected to the network when i add a camera. I have now deleted those cameras and it looks like I have to start again. There must be an easier way to do this as restarting cameras from the second floor...

how can you do a manual search if you do not know the ip address of the camera, could you use config tool and set it to static as video below? How to use Smart Config Tool to locate a Dahua IP camera on a network (youtube.com)

Hi Bigred fish, is there a way to reset without connecting to NVR as my NVR doesnt have a 12v port. Could I connect to 12v port and PoE and reset that way?

No didnt touch the cable which caused the error message. since then I removed the cable waited 5 minutes, rebooted NVR. Added cable waited 5 minutes, refreshed camera list. Camera not appearing.

I have seen that the cameras as set to a static IP address should they be DHCP?

NVR: DV-NVR5208-8P-4KS2E Camera: DH-IPC-HDW3849H-AS-PV-ANZ I found the camera in port 1 when plugged in and refreshed although the camera in port 3 had the error cannot find network host. I deleted the camera waited 5 minutes, rebooted the NVR and added the camera through PoE which is the same...

Does the NVR show the ability to look at the ARP table? Need to confirm Is the NVR the only DHCP server on the camera network? Yes Does the NVR DHCP server settings look good? (I'm guessing which is handing out 10.1.1.0 addresses to the cameras) Yes its the same address as the LAN and my...

I am connecting 6 camera directly to Dahua NVR PoE switches all new devices. The cameras are Dahua 8MP Smart Dual Illumination Active Deterrence Eyeball WizSense V3.0 8MP Full-color. The NVR is set to DHCP and is on the same subnet as my router and local internet network (NVR and router...