Recent content by WalkeJ

It still does not save any snapshots from the ActiveX web client. I can save snapshots from within BI, but not from the web client.

I have the camera setup in a spot in my house where I can PT to look into my computer room, my front door, my living room and my bedroom. I do have it set to dwell on motion detection, but I have not configured any motion detection as yet anyway. Even after a reboot, the presets are not...

That limits where I can put it without running Ethernet Cable.... Sure was hoping that I was just doing something wrong here in the setup.

I have an EasyN FS-613A-M136 which appears to the a "clone" of the Foscam FI8910W. The WiFi acts very strange. I can not connect to the camera via the WiFi, but can connect when using the hardwire Ethernet interface. If I unplug the Ethernet cable, then the camera connects to my router via...

I have an EasyN FS-613A-M136 which appears to be a "clone" of the Foscam FI8910 model. The preset PTZ positions do not appear to hold the same position over time. After selecting the presets several times, the position that it actually goes to drifts left (and down). Does anyone else have...

Hmmm. Ok. This EasyN camera appears to be a "clone" of the Foscam FI8910. Can I assume that none of the Foscam models will be able to maintain their preset positions with time, even the more expensive ($200 FI9826W) models.

When I am using the BI ActiveX web interface and click on the "Camera Icon" (I assume this is to take snapshots), no snapshot is taken. If I click on the "Snapshot" icon in the toolbar of the BI Interface on my computer, snapshots are taken. What am I missing?

I am using BI with a EasyN FS-613A-M136 camera. I have found that when patrolling preset PTZ positions, it drifts left with time. After running through a few cycles, the camera ends up pointing left of all of the preset positions. Does anyone know what might be causing this? Help!

Thanks! I did not find anything in the help file on the web interfaces, but maybe I just missed it. Duh! That makes sense. My camera only has Pan/Tilt and no zoom. I should have figured out what those buttons would be for. It would be nice if they added the other five preset buttons to...

I can't seem to find a "manual" or description of how to use the JPEG Refresh Interface for BI. Is there a good description of the buttons and what they do? What are the two "A" and "A" (smaller) buttons? Is there a way to get to more than 5 of the presets? What are the settings necessary...