Recent content by Tim Briggs

I purchased this gem from Andy, and it has worked great, highly recommended. It has been unplugged for several weeks. Now I cannot log in. Tried the passwords I setup and nothing. Tried the defaults, nothing. Tried the date one, assuming both today data and a default year 2000 one. I cannot...

I'm in the market for a couple of dahua watertight connectors. I destroyed two of the ones that come ready to load onto an eth cable. Thanks.

That did it. The NVR changes the IP of the camera - permanently- once I changed the subnet of the new test network. all is good.

also note the camera was connected to the NVR first. Does the NVR change the IP and settings automatically?

Well. I took a computer and router, not internet connected. Told the new router that DHCP leases are in the 192.168.1.0/24 network. The router has 1.1 the computer has 1.2 A new dahua plugged into the router should be reachable correct? With The Config tool? I't not, and I'm not sure why. The...

Thank you. I did suspect same IP problem. I have not yet reconfigured the IP's that's today's project.

The home network is a netgear router r7000, the NVR WAN port is connected to the r7000. The trendnet poe swtich was connected to the NVR POE ports, only 1 camera works when I connect it this way) I have tried the WAN port of the NVR to the Trendnet switch, then the switch to the router, cameras...

Single Eth for network is connected to my network. The trendnet switch is connected to the camera POE's

A bit of help, tutorial or just point me to the RTFM page :). Equipment - 5216 16 P 4kS2 POE NVR, from Andy, works great, 3 camera 2 bullets and 1 dome, from Andy, work great. I want to run 1 eth cable from the NVR to a POE switch - 1st floor (NVR) is upstairs. Then hang off that switch...

I've asked the seller for a refund. I'm just testing now to see if it could possibly come back, alive.

Log file : Ncat: Version 7.40 ( Ncat - Netcat for the 21st Century ) Ncat: Listening on 192.168.254.254:5002 gBootLogPtr:80b80008. Check spi flash controller v350... Found Spi(cs1) ID: 0xC8 0x40 0x18 0xC8 0x40 0x18 Spi(cs1): Block:64KB Chip:16MB Name:"GD25Q128" partition file version 2...

Well I've followed all steps here, Dahua IPC EASY unbricking / recovery over TFTP, according to the page, my model is included. I've tried 3 times to flash. TFTP transfer takes place, no noticeable errors. Attempted to log in via config tool and default 192.168.1.108 ip and nothing. Spun up...

Thanks again. NO reset button, so either I go after my money back, or spend some time with learning firmware upgrades, perhaps only to find other issues. I've purchased two other cameras from Andy, here, waiting on those. I've found numerous pages and links to ali for cameras here, is there a...

Dahua 4MP POE CCTV camera HFW4431R Z (HFW4300R Z)2.8~12mm Varifocal Motorized Lens English firmware IR Network IP Bullet Camera-in Surveillance Cameras from Security & Protection on Aliexpress.com | Alibaba Group

So this device is using ip 10.1.1.66, And default creds don't work... Is there a way to reset the device back? I found it by trying a single network with a single device on first the 192 subnets then the entire /8. and It appeared. Hopefully I can break the creds or reset this.