Recent content by SYN

  1. SYN

    DS-7608NI-E2/8P & IP change

    Uh. I feel so stupid. Turns out I connected my lan cable to the PoE port, that's why I had all of this problems. I though it was just like my other typical PoE switch. Thank you very much for your help Gateway address isn't really relevant. Usually just set gateway to your router's IP, since...
  2. SYN

    DS-7608NI-E2/8P & IP change

    Thanks a bunch. Upgraded from v3.3.4 to V3.4.1. Did a reset. And the following happened: 1- I was able to change the IP through the HDMI-Monitor route, and it remained the same after the reboot. But when I checked in SADP, the IP address appeared to be the internal NIC IP of the NVR, not the one...
  3. SYN

    DS-7608NI-E2/8P & IP change

    I did that, and it showed the new IP, but I checked with SADP, and it showed the old IP address. Also, when I restart the NVR it goes back to the old IP address. Didn't try to change any of the other settings yet as I still trying to figure out the IP issue. Just emailed Hikvision customer...
  4. SYN

    DS-7608NI-E2/8P & IP change

    I Downloaded the latest SADP and it's the same issue. Tried also with iVMS-4200 and it's still the same. Tried to connect it to a monitor, and accessed it via the remote. Changed the IP and everything. Pressed Save. Then when I check with SADP the old IP is still there :nonchalance:
  5. SYN

    DS-7608NI-E2/8P & IP change

    I can't access web GUI because it's not in my IP range.
  6. SYN

    DS-7608NI-E2/8P & IP change

    Hello there, I just bought this NVR with a couple of Hikvision cameras. My problem is every time I access SADP to change the IP address of the NVR, it says "Parameters modification completed" but when I refresh it goes back to the old IP address right away. I have changed the IP address of the...
See more
Top Bottom