Recent content by steve457

I found a way to fix this problem thanks to a tip from Andy. Go into the storage schedule, disable Intelligent, reboot, and then re-enable it. I did this and all cameras now appear to be displaying correctly.

I'm in the process of upgrading my Hikvision setup to Dahua and am selling off all my old stuff. I originally purchased everything from LTS Security, who was a vendor on this forum at the time (not sure if they still are or not), so all my cameras are USA versions and upgradeable via firmware. I...

Yep, this definitely seems like one of those mysterious computer issues! In fact, I just checked and noticed that one of the channels just decided to "fix itself", even though I didn't touch any of the settings around then. I guess I'll just cross my fingers and hope the other channels that are...

Channel 1 and 2 are the ones that seem to only show a continuous blue bar, so I tried removing all cameras and only adding a single camera back (one that had correct green/yellow bar behavior). The camera now in the channel 1 slot, also only shows a continuous blue bar now so there is definitely...

Yes, it is using the private protocol, port 37777. What is even stranger is that two channels are on the same physical camera (boobie cam 4MP), and one channel is showing continuous blue, but the other one is fine (mostly green, with yellow or blue lines).

Tried deleting the cameras and then adding them back, but the problem still persists.. just a continuous blue bar.

Hmm, ok I will give that a try. What is interesting is that previously I had Hikvision cameras attached as the cameras which would show the continuous blue bar, but I figured it was due to the non-Dahua camera. Now that I swapped the cameras out for Dahua cameras I figured the problem would go...

I can't figure out why some of my cameras are showing a continues Intelligent event when searching on my Dahua NVR. Each of these cameras has a IVS line crossing trigger, and all of them are also set to record continuously. I'd expect to see green (general) most of the time, with bits of yellow...

Thanks all. I turned the FPS down to 15 and 24, am using H265 and 4096 bit rate and it seems to run smoothly now.

Oh, I was running at 30fps. I will turn it down and try that.

I just got my camera mounted yesterday, but noticed it has what I believe are CPU issues if running both streams using H.264, CBR, 8196 Mbps. I noticed the recordings where extremely jerky and missing frames, and when I looked at live view on the camera directly noticed the same thing. In fact...

I have my cams/NVR on a VLAN with no access to the WAN/Internet. Maybe I need to allow port 8888 through?

Ok, I enabled the Tripwire and Intrusion notification, but didn't seem to get any alert when the IVS triggered.

How do you setup your cameras and NVR to enable push notifications through DMSS? I found the setting in the DMSS app, but would I also need to enable something on the camera? I already have IVS setup on the camera and it sends me an email, just want to enable the alert on the app as well. I...

Oh, I think I may have found the answer to my own question.. AI Search! That seems to be what I'm looking for.