Hi,
I was looking for 2 LPR camera for my driveways. I settle for the Dahua HFW5241E-Z5E, but because of the shortage there was only 1 left on aliexpress so i settle for 1 5241 and 1 HFW5231E-Z5E, which is supposed to have the same focal lenght and same sensor, but a tiny worst aperture at...
Hi, i used to use the AI tool with deepstack, but at some point a windows update broke it and i wasn’t able to fix it easily so at this point i settle to try the new ai built-in to blue iris to replace the AI tool.
The main objective for me to use AI is to save disk space by not recording...
do you have some in mind?
i am planning in the future to start to mess with MQTT to send alert and also receive information from "home assistant" about the presence of owner or not so i can play with activating and deactivating the trigger event when working in the garage. Will that work the...
thanks for your answer so in the case of senario 1, which is the proper way to do it since may 2020, i should not have increase in cpu (BECAUSE of the action of triggering a camera). i get that motion and AI will take CPU, that's normal and i can live with it. if i understand correctly then i...
@wittaj, i would like to test something and i need other camera brand to do it so i will need your help.
Before that, i did a test comparing the different way to have the camera feed blue iris
1st
i setup the r125hd: RTSP:/main 4k and sub 360p (motion sensor OFF)
setup the r125: RTSP:/main 4k...
i am not planning to use the built in ai in the reolink and the video you linked just confirm it is good to ignore any AI from reolink.
I don't understant your point on cloning cameras... i know that the 4k streams didn't switch to SubStream because i don't run motion detect on them it should...
@wittaj the substream is beeing pulled, but maybe i explained myself incorrectly.
i have 11 streams 640x360 and 11 streams 3840x2160.
the 640x360 have motion sensor enable and are set to record continious. when the low stream is triggered it send a picture to a watch folder "aiinput" which the...
thank you @SouthernYankee and @wittaj for your input, on other place i saw that adding the RTMP substream instead of the RTSP help a lot
rtmp:/[camers ip]/bcs/channel0_sub.bcs?channel=0&stream=0&user=[username]&password=[password]
now i get 15 fps on both stream. I add the other 10 cameras i...
hi,
i'm new to blue iris and i tried the demo version to setup my first camera (RLC-820A latest firmware) following the Hook up video i have setup 2 stream in blue iris, 1 24/7 640x360@15fps recording and 1 AI motion detected 3840x2160@15fps. Both are setup direct to disk recording. In the live...