Recent content by shocked277

I just wanted to catch everyone up to speed. I used a NetGear 3400 router, and assigned a static ip to the wan port of the router with a 10.0.0.1 ip address and assigned the nvr with a static ip of 192.168.1 bla bla and port forward the nvr and all worked just fine....Thanks again for all your...

Yes it needs to be remote from any where in the hospital not from outside the hospital. the 20 cams or 30 cams was I already installed 8 analog on their existing system but their remainder of 17 hd ip cams 9 at one campus and 8 at the other campus I have not... the NVR,S I am using to do that...

Yes well I guess the biggest problem is that I have a contractor in the same 2 hospitals that has always wanted to get the work I have. They were asked by a separate department to install some ip cameras. So in essence they were the first to do the IP Cams in this hospital and now I am following...

I understand and that I in the future and I will have some time to look in to that , about a year in the future. I for now just need the 10 cameras on a single NVR at one location. you are correct in saying some will have to plan out the infrastructure for the future project. I just want to get...

Well the 600 ip addresses came from....they currently have about 600 analog cameras working between the 2 hospital campuses .... I know they want to start changing analog cameras out for IP HD cameras. I am starting this process with about 20 for now to see how it goes. The It Department has...

If I create a network with a router and just port foreword the NVR and plug everything else in to the NetGear prosafe switch then it should work?

The IT department did not know I had a NVR with only one nic. I did not know I needed 2 nic cards till I saw my competitions NVR with 2 nic cards. This made me say hummmmmmm. Now it looks like I have to leave my current NVR vendor and find a vendor who has NVR,S with 2 nics. any suggestions , no...

I have a crest NVR 32CH with one nic card. I also have NetGear prosafe poe (GS110TP-200NAS switches, with 9- 2.4meg poe ip cameras. The IT department will only give me 1 ip address. If I address NVR with the IP,subnet & gateway, and plug everyone in to the prosafe switches will it all work or...

Self employed electrician, I mostly install low voltage now, card access, nurse call, cameras etc. I am now getting in to ip cameras, this is some what new to me. Networking is not one of my strong points. I have some questions about networking. Thank you, Brian