I see that in the VTO Local Settings->System at the bottom there is an Emergency Maintenance setting for Tuesday at 2:00 AM .. maybe turning this off will eliminate the notification.. it doesn’t bother me so I leave it on..
I have wireguard set up on my edge router 4 and wireguard iOS app has a setting to always on VPN when outside of certain wifi (i.e. when outside of my home wifi, it automatically turns on the VPN).
But then, are you recording all the time? Or only on motion detection etc?
If yes, wouldn't that eat a lot of space, especially if you have more 4k cameras?
I do have the VTO 2211G-WP and me and my wife have the DMSS iOS app and we both can answer the ring and open the door from the app but I haven’t yet connected it to an NVR .. I will in the near future and I will reply here (if I don’t forget )
Meanwhile I can answer from the phone or indoor...
I have this video intercom and was looking for this recording function.
While searching I read more carefully the datasheet. This is what is stated there:
“
Video Motion Detection
• Auto Snapshot (enabled via indoor monitor)
• Record Videos (requires an SD card in the indoor
monitor)
“
I have the Dahua Vto2211g-wp (https://www.dahuasecurity.com/asset/upload/uploads/cpq/DHI-VTO2211G-WP_datasheet_20200720.pdf) which has ethernet with poe and wifi and I know there are plugins to integrate it over HA but haven’t done it yet.
“Unlike the Dahua NVR or IPC, there is NO PASSWORD RESET CAPABILITY!!! For the VTO, you have to press 5 consecutive times the "intrusion detection switch" (keep note that the alarm will go on and off until you hear a distinct beep, which means your VTO is factory reset and the admin/admin combo...