Recent content by plexrva

  1. P

    PTZ425DB-AT Night Time

    Interesting. Part of the reason I went with this one was the form factor was less obvious. Within the next few months I am planning to put a normal PTZ elsewhere on the house but might swap it with this if I can not get the IR issues resolved. I am thinking about 3D printing a black matte...
  2. P

    PTZ425DB-AT Night Time

    Any advice or experience dealing with gutters causing the issue? Matte white tape is an idea. I would like to try avoid moving it for now, once I finish a few more areas I may have to move it anyway but I would like to have it functioning good now.
  3. P

    PTZ425DB-AT Night Time

    I finally got around to getting the ladder and pulling the dome. It was seated correctly (pin and notch were in place) and the gasket was consistent all the way around. Checking the gasket and cleaning the dome didn't help the night time image. I think ya'll are right about IR reflections...
  4. P

    PTZ425DB-AT Night Time

    Odd, I got it new and never opened it. Usually I get the camera installed/configured then do the SD card. I didn't even take the plastic off till installed. I will pull it down later today, and check the gasket. Any idea if Windex is okay for the dome?
  5. P

    PTZ425DB-AT Night Time

    I am trying to improve the night time image quality of my camera (PTZ425DB-AT) on my driveway. Currently if I don’t have ICR on all I get is a black image at night. The camera is set in self-adaptive mode with default settings (Aside from ICR which is auto/medium/10 sec). I have played with...
See more
Top Bottom