Recent content by PattyMorr

You are almost there, couple of enter commands give you # # # # rm /config/*.cfg rm: can't remove '/config/*.cfg': No such file or directory # [01-12 02:01:52][3][641]process message routine begin... no interrupts reset eth0. [ 6811.188844] ***link down status changed***. Looks like...

Assembled camera, assigned credentials and static IP and tested working perfect on ONVIF . Thanks a lot for detailing tutoring and patience. Patty

Restored bootargs line to original as indicated, Boot as normal. Yes indeed camera is inactive now. Thanks a lot for guidance

Went back and repeated the process until I had a prompt from here setenv bootargs console=ttyAMA0,115200 init=/bin/sh single debug=9 saveenv reset help # Then before /etc/init.d/rcS I did # help Built-in commands: ------------------ . : [ [[ alias bg break cd chdir command...

Got lost somewhere # rm /devinfo/ipc_db* rm: can't remove '/devinfo/ipc_db*': No such file or directory

Perfect . I am open to keep going with this. Did not reboot or reset , not able to stop at any promt , probably use Ctrl C when asked?. either way I hit a couple of enter and send the commands # /etc/init.d/rcS Starting udev: [ OK ] diagnose_way = 14, repair_way = 0, interval = 60 route...

This is after commands setenv bootargs console=ttyAMA0,115200 init=/bin/sh single debug=9 saveenv reset help U-Boot 2010.06-253629 (Feb 06 2017 - 15:45:03) Flash: 16 MiB DRAM: 256 MiB Hit Ctrl+u to stop autoboot: 0 HKVS # setenv bootargs console=ttyAMA0,115200 init=/bin/sh single debug=9...

To confirm is a CN original camera out of a red box , attached a picture of camera and the box for the replacement. Yes, I tried the HK tft updater with same results Acivated not psw reseted. This came out of prtHardInfo and dmesg # # [01-11 18:32:47][3][637]process message routine begin...

Thanks a lot for quick reply. Here from Help U-Boot 2010.06-253629 (Feb 06 2017 - 15:45:03) Flash: 16 MiB DRAM: 256 MiB Hit Ctrl+u to stop autoboot: 0 HKVS # help ? - alias for 'help' base - print or set address offset bootm - boot application image from memory bootp - boot...

CN Original Camera 2017 (B) Version Lost password. TTL Com4 /TFtp32 , 13MB Before Firmware Update DS-2CD1221D-I3 Active 192.168.1.4 8000 V5.4.24build 170124 192.168.1.1 V1.0 build 161228 1/10/1970 5:40 I Had a hard time Looking for a suitable Cn Firmware and found a list...