Recent content by Matt2017

  1. M

    Firmware Upgrade for IPC-HDBW4631R-AS

    I to had this question. What I've learned so far: DH_IPC-HX5X3X-Rhea_MultiLang_NP_Stream3_V2.800.0000013.0.R.191202.bin = Worked for updating my camera web-x.squashfs.bin = could brick your camera and require serious efforts to repair, one of my cameras I did this to I now have to try a serial...
  2. M

    IPC-HDW5231R-Z IP address constantly changing

    Well I'll be damned, that is exactly what happened to mine. I held the reset button for like a minute straight and then was able to configure via the 192.168.1.108 address. Since my problems seemed to start when I set the date/time I got suspicious of default NTP server and turned it on directed...
  3. M

    Dahua SD59225U-HNI Bricked! Anyway To Recover?

    @aseba Did you have any luck on this?
  4. M

    IPC-HDW5231R-Z IP address constantly changing

    Well, this is going to remain a big mystery. I took the camera down, performed a factory reset by holding the button manually inside the camera for a minute. Restarted, set up the camera, and now it is back to working fine.
  5. M

    IPC-HDW5231R-Z IP address constantly changing

    No. From a complete factory reset. Access via default IP address, set password, log in set static IP address of 192.168.4.200. Camera works fine, can connect to Blue Iris everything is good. Log in to camera Set Date/Time in web config. Camera disconnects from Blue Iris, no longer accessible...
  6. M

    IPC-HDW5231R-Z IP address constantly changing

    That is what is perplexing me, I have tried a static IP set in the camera itself. But 100% of the time I set the date/time in the camera it starts alternating between the two IP addresses, only becoming accessible via the web interface for a few seconds at a time. And, as luck would have it, I...
  7. M

    IPC-HDW5231R-Z IP address constantly changing

    I run my normal network on 192.168.4.1/23 with 255.255.254.0. Being lazy and temporary in order to more easily gain access to the default ip address range of the cameras at 192.168.1.108 I expanded the subnet to 255.255.0.0. Which worked fine for accessing the default IP address.
  8. M

    IPC-HDW5231R-Z IP address constantly changing

    I've tried it both ways, either way if I set the date/time in the camera web interface the ip address cycling starts occurring.
  9. M

    IPC-HDW5231R-Z IP address constantly changing

    It is a ubiquiti system with a USG (which is the router (to my understanding)) and then a couple of switches that do POE.
  10. M

    IPC-HDW5231R-Z IP address constantly changing

    So, I was trying to migrate my cameras from a Dahua NVR to Blue Iris. I was able to web browser into the camera (IPC-HDW5231R-Z) and do a factory reset. Everything worked fine. Then I ran into a problem where the camera kept becoming unavailable via the web browser. When I looked at my Ubiquiti...
  11. M

    Review-Dahua DB-11 Video Door Bell

    I the NVR and the DB-11, I can get it to record continuously, I have not been able to get it to record motion detected yet.
  12. M

    Dahua 2MP 25x Starlight IR PTZ Network Camera (SD49225T-HN)

    Thanks, they all looked round to me which is why I wasn't sure. I was expecting a rectangular connector, but guess it makes sense for weatherproofing.
  13. M

    Dahua 2MP 25x Starlight IR PTZ Network Camera (SD49225T-HN)

    I feel like this is a silly question, but how to you connect an ethernet cable to this camera? I'm look at the pictures of the wiring leaving the camera and not grasping it.
See more
Top Bottom