Recent content by larasker

Hi, I found the solution! I had to enter through the browser: such as specifying http://192.0.0.64/config In the popup window I could set Pelco-D and management, thank you very much!

Thanks for answering Mel42 is correct, because I have the camera at 9600 baud RS-485, however in the browser have no option to configure the Pelco-D protocol, you know to set the protocol using telnet some command? Greetings!

Hello, I have a camera IR239 company GUIDE. It is an IP camera and inside has a Hikvision DS-2CD8313PF-E. Recently I set the camera to its Factory settings using a web browser. Since I did this I have no control over the movements of the camera, I can only see the IR image, but I can not move...