Recent content by jimp180
-
J
New RCA HSDB2A 3MP Doorbell IP Camera
Thanks David L, I use Linux computers and didn't have a windows computer setup to run the batch config tool so after many attempts to load win 10 on an old laptop with a failing hard drive (apparently) I figured it out and got it installed. I was able to get to SYSTEM->SYSTEM MAINTENANCE->Remote... -
J
New RCA HSDB2A 3MP Doorbell IP Camera
I found this thread as i'm sure many did because of the changing firmware to make a doorbell work better, so I have a ezviz DB1 running 240617 , I also have a reolink poe which has replaced it on my front door. I have the DB1 on the walk through door to my garage and would like to set it up... -
J
EzViz Doorbell Help
No that is the problem, I have purchased a Shelly uni along with a 24v relay and wired it as per Deep Dive into the EZVIZ DB1 Doorbell with Home Assistant hoping the problem was my new chime but i dont trip the relay either -
J
EzViz Doorbell Help
So I can only assume my doorbell is faulty, or the firmware is corupt and not breaking/making signal? If its a bad doorbell does anyone know of another way to get the button push to HASS? -
J
EzViz Doorbell Help
can someone tell what is supposed to happen electrical to the circuit when the door bell is pushed? I have wired this according to EZVIZ with the included power kit. I know the doorbell button works because it makes its outside chime noise and EZVIZ calls my phone but there is absolutely no...