Recent content by Jeremeyh

I'm going to replace it with the new line 7 anpr DS-2CD7A26G0/P-IZHS but will try and fix it once the new one is installed.

I'm guessing it's a manufacturing flaw? It's only 2 years old. Or is it common? I'll try a heat gun to soften the adhesive like they do on cellphones, or is that likely to damage the lense?

Hi all. I have a DS-2CD7A26G0/P-IZ(H)S which is about 2 years old. I've recently noticed bad images in the morning and at night. Upon inspection the lense seal at the front seems to have broken down. Is there any way to remove it and reseal it?

They actually customised a firmware for me to let me store 5000 blacklist plates. It's a new Zealand version. V5.4.7 build 181026 It works pretty well

My Noctua fan arrived today. The NVR is noticeably quieter. Definitely worth the $35.

Good thinking. I've ordered a new fan for the power supply which will run at 14db vs the stock one which runs at 30db. NZ$ 36.82 | Noctua NF-A4x20 FLX 40mm 40X40X20mm 5000 RPM 14.9 dB(A) PC Cooling Fan Cooler Fan Radiator fan Computer Cases & Towers Fan NZ$ 36.82 | Noctua NF-A4x20 FLX 40mm...

I have ordered a new fan to replace the stock power supply fan, which runs at 30.2db. the Noctua fan runs at 14db which should make the NVR a lot quieter.

My thinking exactly. And then disconnect the small NVR fan. I think it will help with the noise too

Thanks. I have the NVR on a surge protector, but I think your right about the heat. I had a tv decoder sitting on top of the NVR which puts out a bit of heat so wouldn't have helped the power supply.

I think heat may have been an issue. I had a tv decoder sitting on top of the NVR and a couple of weeks prior to it dying the fans were clogged with dust. Plus I just added the 10TB drive which would have made more heat. I'm thinking about adding a bigger fan to help remove heat from the unit

Poe specs

Hi I have a DS-7608NI-I2/8P NVR running 3 cameras, one of which is a DS-2CD4A26FWD-IZS/P ANPR. My power supply has just died, and I have ordered a new one. Once I have installed it I'm wondering if I can use a Poe injector with the anpr camera to relieve some pressure off the NVR Poe as it's...

Hi I have a DS-7608NI-I2/8P NVR running 3 cameras, one of which is a DS-2CD4A26FWD-IZS/P ANPR. My power supply has just died, and I have ordered a new one. Once I have installed it I'm wondering if I can use a Poe injector with the anpr camera to relieve some pressure off the NVR Poe as it's...

My NVR is a Hikvision, thanks I'll Google it after work. That's pretty good for a 2MP!